Tuya Developer Forum

Hi, if you can expose that temperature and humidity sensor:

Virtual ID of that sensor:
bf118a868a72f10be5g134

Virtual ID of the hub:
bf01ab90188976b3f7xqtl

Thank you.

Hello, I have added bridge support for this temperature and humidity meter. You can restart your Matter gateway to verify it.

Thanks, it's working.

fangping.guo 2026年 Jan 12日 09:43

Hello, I have added bridge support for this temperature and humidity meter. You can restart your Matter gateway to verify it.

It's keeping reporting battery status as 2%, I think its beacuse in tuya app, battery level status is high, normal, and low. So I think it's better just turn off battery status in Matter, or make that high is reported as 100%, normal as 50%, and low maybe as 10%.

Battery Status In Aqara App:

Battery Status In Tuya App:

Virtual ID: bf118a868a72f10be5g134

Thanks.

It has been updated. You need to unbind it and (ideally restart the gateway) rebind it to trigger the change.

It's now 0 percent:

But if it can't be fixed, then it's ok, it's better than 2 percent hah, and no big problem.

Thank you.

It has been updated [again]. You need to unbind it and (ideally restart the gateway) rebind it to trigger the change.

fangping.guo 2026年 Feb 24日 09:28

It has been updated [again]. You need to unbind it and (ideally restart the gateway) rebind it to trigger the change.

Thanks, wokring as intended.