T5 EVB更改demo的LCD引脚配置之后驱动不了LCD，没看到SCK和MOSI的引脚配置在哪里。
P44->SCK
P46->MOSI
P47->DC
P19->BL
P18->RST
P17->PWR
#elif defined(T5AI_BOARD_EVB) && T5AI_BOARD_EVB == 1
// #define LCD_SPI_POWERON_PIN GPIO_7
// #define LCD_SPI_RESET_PIN GPIO_6
// #define LCD_SPI_BACKLIGHT_PIN GPIO_5
// #define LCD_SPI_RS_PIN GPIO_17
lcd->ll_ctrl.power_ctrl_pin = TUYA_GPIO_NUM_17;
lcd->ll_ctrl.power_active_level = TUYA_GPIO_LEVEL_HIGH;
Code: Select all
lcd->ll_ctrl.bl.io = TUYA_GPIO_NUM_19;
lcd->ll_ctrl.bl.mode = TKL_DISP_BL_GPIO;
lcd->ll_ctrl.bl.active_level = TUYA_GPIO_LEVEL_HIGH;
lcd->ll_ctrl.dc_pin = TUYA_GPIO_NUM_47;
lcd->ll_ctrl.dc_cmd_level = TUYA_GPIO_LEVEL_LOW;
lcd->ll_ctrl.rst_pin = TUYA_GPIO_NUM_18;
lcd->ll_ctrl.rst_active_level = TUYA_GPIO_LEVEL_LOW;
lcd->ll_ctrl.spi_using_qspi = FALSE;
lcd->ll_ctrl.tp.tp_i2c_clk = TUYA_GPIO_NUM_MAX;
lcd->ll_ctrl.tp.tp_i2c_sda = TUYA_GPIO_NUM_MAX;
lcd->ll_ctrl.tp.tp_rst = TUYA_GPIO_NUM_MAX;
lcd->ll_ctrl.tp.tp_intr = TUYA_GPIO_NUM_MAX;